Air Dam - Full Width

Here is a full width ONE-PIECE air dam for those of you running front mount intercoolers or if you have a non intercooled hot air car. Hides the pipes that hang down giving your car more of a stealth look. This is a made from scratch piece that has been in development for months and is finally available.

The dam is approximately 1" lower to the ground than the stock air dams and has a small lip at the bottom. Looks similar to the material used on the original air dams. It is made of high tensile strength Polycarbonate plastic with Korad. The Korad gives the plastic ultra violet light protection so it will resist fading. Unlike fiberglass, this material has some give like the stock air dams in case you hit a parking curb. Some minor enlarging of the mounting holes may be needed.

This air dam has been tested by the manufacturer at Indianapolis Raceway Park and Quaker City Dragway. It will not fold under the car at speeds of over 150 MPH!

Remember, this is for use on Turbo Regals that are running FRONT MOUNT intercoolers OR the 84-5 Turbo Regals that do NOT use an intercooler at all.
If you are running a stock location intercooler this is NOT for you.

Shipping is expensive as they have to go oversize rate due to the size of the box. These are shipped directly from the manufacturer.

I put one of these on my own GN as seen below.

NO HARDWARE INCLUDED

NOTICE! SHIPPING IS VERY EXPENSIVE ON THIS ITEM.
IT COMES IN A HUGE BOX!