GLOVEBOX PLATE PAGE

These plates attach over the existing panel located above your glove box door. Strips of special double tape are already installed on the back of the panels. Just peel off the backing and position in place. They are made in the same gloss black material as the original panels of your main dashboard.. The logos are actually engraved from the back of the panel and then hand painted. The front surface is totally smooth! The plates can be made with your choice of the pictured logos or custom engraved as well.

Where did the GM logos go??
We have been contacted by General Motors legal department concerning the use of trademarked logos on the items we sell, and they have demanded that we no longer advertise any items that have a GM trademark. The basis of trademark law is the issue of "confusion", that our customers may believe that they are buying a licensed genuine GM item.
We have always made it clear that
we do not make imitations of any GM parts.
But we don't have the resources to litigate this issue, so we must comply with their demands. Therefore, we do not show any pictures of an item with a trademarked GM logo. We of course as always offer custom engraving on most items, and we have come up with a few "generic" logos that are "acceptable".

HOWEVER, AND THIS IS IMPORTANT: While the law may say that we cannot show photos or renditions of trademarked logos, there is NO LAW that prevents us from supplying you with anything you want for your vehicle, including any additional artwork or graphics. Therefore, if there's any type of artwork or graphic you want added to your item and it's not on our website, just ASK, or provide us with some artwork of what you'd like. We will gladly meet your request, if possible. Please note that a small extra nominal charge may apply depending on what you request.

VERY IMPORTANT NOTE!
THESE GLOVEBOX PLATES ARE FOR GOING OVER THE STOCK FLAT PANELS COMMONLY FOUND IN THE 84-7 GRAND NATIONALS. IF YOU HAVE A STOCK PLATE THAT IS SUNKEN AND HAS A LARGER RAISED BORDER AROUND THE PERIMETER WE WILL NEED TO KNOW THAT UP FRONT SO WE CAN MAKE THE PROPER ONE FOR YOU! THOSE TYPE OF PANELS ARE USUALLY ON PLAIN REGALS OR LIMITEDS. BELOW IS A STOCK EXAMPLE OF WHAT WE MEAN BY A SUNKEN PLATE. THE PLATE FITS INSIDE THE BORDER AND MEASURES APPROXIMATELY 1.75" X 14".

Glovebox plate of an 87 Turbo Regal Limited, notice the raised border around the perimeter.

These black anodized aluminum and SIMULATED aluminum panels compliment our dashboard kits and look great! These differ from the above Gloss Black panels as the black anodized finish is flatter in appearance and has the engraving done from the front.

The simulated aluminum has the appearance of aluminum but is a plastic material. Engraving is from the front and will be black. Compliments our simulated aluminum console and dash kits to totally change the appearance of your interior.

THIS ITEM IS AN OVERLAY ONLY!
DOES NOT INCLUDE ANY FACTORY PARTS.

Anodized Aluminum Glovebox Plates
Available in Simulated Aluminum or Black Anodized aluminum finish.
Price $35.00 - $45.00

Quantity

SELECT YOUR GLOVEBOX PLATE BELOW
BE SURE TO ORDER THE PROPER FINISH ALSO!

IMPORTANT!!!
LET US KNOW WHICH STOCK GLOVEBOX PLATE YOU HAVE!
Flat Stock Panel
(Approximately 2.25"X14.5" - This is used in ALL 84-7 GN's)
Raised Border Around Perimeter
(Approximately 1.75"X14")

Do your want any custom engraving on this plate?

What custom engraving do you want? Enter it below!

VERY IMPORTANT! PLEASE DO NOT USE THE QUOTATION MARK SYMBOL IN THE BOX BELOW AS THIS MESSES UP THE SHOPPING CART CALCULATIONS!